Aaron's Homepage Forum
Aaron's Homepage Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 Electronics
 Auto
 12volt alternator down to 6volt for vintage car
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

cjarvo
New Member

United Kingdom
4 Posts

Posted - Dec 11 2004 :  2:52:49 PM  Show Profile  Reply with Quote
My idea is to fit a modern car alternator on my 1935 Ford car which has 6volt electrics.
I need a schematic/list of parts for a zener type voltage control without limiting the current capability please?

cmj

Aaron Cake
Administrator

Canada
6718 Posts

Posted - Dec 12 2004 :  10:38:19 AM  Show Profile  Visit Aaron Cake's Homepage  Send Aaron Cake an ICQ Message  Send Aaron Cake a Yahoo! Message  Reply with Quote
Are you sure that such a product doesn't already exist? I would find it hard to believe that with all those 6V cars out there, no one would have thought of this. Finding a commercial product is probably the best idea, because building reliable and small regulators greater then about 15A becomes a challenge.

Have you contacted a local alternator shop?

Go to Top of Page

cjarvo
New Member

United Kingdom
4 Posts

Posted - Dec 13 2004 :  08:29:35 AM  Show Profile  Reply with Quote
Thanks for the tip! Beleive it or not Iv not been able to find a commercially available product. I live near Brighton, Sussex UK.
If you have any suggestions about a supplier, Id be very grateful.
In the meantime, I have considered your comments and am now thinking about the fitting of a 12volt alternator, and using a step-down circuit for things like the windscreen wiper motor. Apparently the 6volt starter motor handles 12volts ok as it is not in use for more than a few seconds, so if you could let me have a schematic for the circuit up to 15amps, which would be more than adequate, I'd be grateful. Thanks, Chris Jarvis

cmj
Go to Top of Page

Aaron Cake
Administrator

Canada
6718 Posts

Posted - Dec 14 2004 :  1:22:56 PM  Show Profile  Visit Aaron Cake's Homepage  Send Aaron Cake an ICQ Message  Send Aaron Cake a Yahoo! Message  Reply with Quote
Take a look at the High Current Power Supply on the circuits page. The regulator section there should do the job.

Go to Top of Page

cjarvo
New Member

United Kingdom
4 Posts

Posted - Dec 14 2004 :  2:34:03 PM  Show Profile  Reply with Quote
Hi Aaron,
Sorry to be dim mate, but I couldn't see the power supply circuit you referred to on either page.....
Who was the author please?
Thanx anyway,
Chris

cmj
Go to Top of Page

Aaron Cake
Administrator

Canada
6718 Posts

Posted - Dec 15 2004 :  3:03:41 PM  Show Profile  Visit Aaron Cake's Homepage  Send Aaron Cake an ICQ Message  Send Aaron Cake a Yahoo! Message  Reply with Quote
http://www.aaroncake.net/circuits/supply2.htm

Go to Top of Page

cjarvo
New Member

United Kingdom
4 Posts

Posted - Dec 16 2004 :  03:06:26 AM  Show Profile  Reply with Quote
Brilliant! Thank you very much.

SEASONS GREETINGS TO ALL + BEST WISHES FOR 2005

Chris Jarvis

cmj
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
Aaron's Homepage Forum © 1995-2020 AARONCAKE.NET Go To Top Of Page
This page was generated in 0.08 seconds. Snitz Forums 2000