8 Note Tune Player

Home > Circuits > Sound/Radio > 8 Note Tune Player

Author	Views	Views Today	Rank	Comments
	143,469	1		12

This neat little circuit can play 8 note tunes at any speed you want. You select the notes with 8 trim pots. The speed in selected through a ninth pot. The circuit draws very little power and can be powered by a 9 volt battery, with the addition of a 7805 regulator to power the TTL logic used.

Schematic

Parts

Part	Total Qty.	Description	Substitutions
R1	1	10K Trim Pot
R2	1	1K 1/4 W Resistor
R3, R4, R5, R6, R7, R8, R9, R10	8	500 Ohm Trim Pot
C1, C3	2	10uF 12V Electrolytic Capacitor
C2	1	1uF 12V Electrolytic Capacitor
U1	1	555 Timer
U2	1	7490 Binary Counter	74LS90, 74HC90
U3	1	7445 BCD To Decimal Decoder	74LS45, 74HC45
U4, U6	2	7404 Hex Inverter	74LS04, 74HC04
U5, U7	2	4016 Quad Bilateral Switch
U8	1	3909 LED Flasher/Oscillator
SPKR1	1	8 Ohm 500mW Speaker
MISC	1	Board, Wire, IC Sockets

Notes

R1 controls the speed at which the notes are played. R3-R10 control the pitch of those notes.

The circuit will operate fine on a 9V battery, with the addition of a 7805 regulator to power the TTL logic used.

The missing pin on U2 is pin 14.

Related Circuits

Comments

Add A Comment

Hero999 8 Note Tune Player Monday, August 15, 2011 12:33:11 PM

Unfortunately the LM3909 is no longer manufactured. It's easy to redesign the circuit with a NE556 in place of U1 and U8. There are better ways to do this. You could replace all those ICs with a single microcontroller, such as the PIC12F508 or a melody generator IC such as the UM66 or M66T.

satpambobo 8 Note Tune Player Friday, August 05, 2011 8:47:04 PM

i imagine this produce funny or wierd song? cause its only use binary count up. But still good for Learning Digital Technique via this Digital ICs. if use EPPROM IC that can save binary data, it can be more fun. 8 bit = do,re,mi,fa,so,la,ti,do...

anonymous 8 Note Tune Player Saturday, April 18, 2009 11:23:38 AM

I don't see what's so hard to understand here: the first stage, the 555 timer, determines the tempo, bpm, or speed of the song. Trimpot R1 is used to adjust this speed. The clock from the 555 timer is put into a timer, which simply counts (so your song is in order). You don't touch anything there. Lastly, resistors R3-R10 control the frequency for each note in the song. The circuit first looks at R3, and plays a note based on its resistance (how far it's spun). It moves on to R4, until it reaches R10 and comes back at the beginning. Hope that helps. PS: You could replace 4016 with transistors, correct?

anonymous 8 Note Tune Player Saturday, March 07, 2009 12:45:34 AM

can you describe the 8note and how can we serch it?

anonymous 8 Note Tune Player Monday, April 14, 2008 11:17:05 AM

do the 8 tones/pitches/notes play in sequential order dictated by the number pots? For example. R3 for 1/4 note ,R4 for a 1/4 note, R5 for a 1/4 note, and so on? Although I'm not new to music or music theory...I am new to circuit building. thanks!

anonymous 8 Note Tune Player Friday, April 04, 2008 4:45:39 AM

pls can anyone telme wat is the alternative for 3909 IC for building 8 note player.. plz

farah 8 Note Tune Player--description Saturday, January 05, 2008 3:35:06 AM

here i request u to plz explain me the circuit's working and does it work surely??...becoz i hav very less time 4 submiting it and i need a working project./..so plzzz guide me...hoping 4 a quick response

hyper_sn4ke 8 Note Tune Player Monday, November 26, 2007 6:34:34 PM

R1 controls the speed at which the notes are played. R3-R10 control the pitch of those notes.!!:D

Pat tpnymous 8 Note Tune Player Tuesday, August 21, 2007 3:54:54 PM

Dear sir: I am building the 8 note tune player, have found that the 3909 led oscillator is obsolete, I was told to use a 555 timer for amplification could you tell me how the wiring should be? having some problems figuring out, your response would be appreciated asap.

samad 8 Note Tune Player Thursday, May 03, 2007 7:13:51 AM

Hi sir some confutin of 9v bettry and other used to 12v adopter use or not so plz kindly answer me ko sir and purpose of 8note tune player and compleate operation and made the circuit connection . iam weatting for your answer samad

The last 10 comments are currently shown. Show All Comments. Add A Comment

If you would like to leave a comment, you can do so using the form below. Comments can be things like suggestions, successes or failures, improvements, similar circuits, error reports, an answer to a previous commenter's question, or anything in between. However if you would like to ask a question it is suggested that you use the forum instead. The forum provides a more robust environment for discussion.

Important: If you post a technical question here, there is no guarantee it will be answered. All technical questions should be posted to the forum. The owner of this site generally does not answer questions in comments.

All comments are subject to approval before they are displayed here, so your comment will not appear immediately. This is done mainly to prevent spam and other abuse. If you wish to remain anonymous, simply enter "anonymous" for your name and/or email.

Name:
Email:
Subject:
Comments:
Anti Spam Code:	Please enter the exact text shown in the image above into the box below. Browser cookies must be enabled to comment on circuits.

Privacy Policy

Hero999	8 Note Tune Player	Monday, August 15, 2011 12:33:11 PM
Unfortunately the LM3909 is no longer manufactured. It's easy to redesign the circuit with a NE556 in place of U1 and U8. There are better ways to do this. You could replace all those ICs with a single microcontroller, such as the PIC12F508 or a melody generator IC such as the UM66 or M66T.
satpambobo	8 Note Tune Player	Friday, August 05, 2011 8:47:04 PM
i imagine this produce funny or wierd song? cause its only use binary count up. But still good for Learning Digital Technique via this Digital ICs. if use EPPROM IC that can save binary data, it can be more fun. 8 bit = do,re,mi,fa,so,la,ti,do...
anonymous	8 Note Tune Player	Saturday, April 18, 2009 11:23:38 AM
I don't see what's so hard to understand here: the first stage, the 555 timer, determines the tempo, bpm, or speed of the song. Trimpot R1 is used to adjust this speed. The clock from the 555 timer is put into a timer, which simply counts (so your song is in order). You don't touch anything there. Lastly, resistors R3-R10 control the frequency for each note in the song. The circuit first looks at R3, and plays a note based on its resistance (how far it's spun). It moves on to R4, until it reaches R10 and comes back at the beginning. Hope that helps. PS: You could replace 4016 with transistors, correct?
anonymous	8 Note Tune Player	Saturday, March 07, 2009 12:45:34 AM
can you describe the 8note and how can we serch it?
anonymous	8 Note Tune Player	Monday, April 14, 2008 11:17:05 AM
do the 8 tones/pitches/notes play in sequential order dictated by the number pots? For example. R3 for 1/4 note ,R4 for a 1/4 note, R5 for a 1/4 note, and so on? Although I'm not new to music or music theory...I am new to circuit building. thanks!
anonymous	8 Note Tune Player	Friday, April 04, 2008 4:45:39 AM
pls can anyone telme wat is the alternative for 3909 IC for building 8 note player.. plz
farah	8 Note Tune Player--description	Saturday, January 05, 2008 3:35:06 AM
here i request u to plz explain me the circuit's working and does it work surely??...becoz i hav very less time 4 submiting it and i need a working project./..so plzzz guide me...hoping 4 a quick response
hyper_sn4ke	8 Note Tune Player	Monday, November 26, 2007 6:34:34 PM
R1 controls the speed at which the notes are played. R3-R10 control the pitch of those notes.!!:D
Pat tpnymous	8 Note Tune Player	Tuesday, August 21, 2007 3:54:54 PM
Dear sir: I am building the 8 note tune player, have found that the 3909 led oscillator is obsolete, I was told to use a 555 timer for amplification could you tell me how the wiring should be? having some problems figuring out, your response would be appreciated asap.
samad	8 Note Tune Player	Thursday, May 03, 2007 7:13:51 AM
Hi sir some confutin of 9v bettry and other used to 12v adopter use or not so plz kindly answer me ko sir and purpose of 8note tune player and compleate operation and made the circuit connection . iam weatting for your answer samad