| 
                 Aaron Cake 
                Administrator 
                      
                 
                
                Canada 
                6718 Posts  | 
                
                  
                    
                      
                       Posted - Jul 16 2009 :  09:58:14 AM
                        
                        
                        
                        
                        
                      
  | 
                     
                    
                       S4.
  It would be very hard to make a rotary idle at 15:1. The idle becomes unsteady if you start to go leaner then 13.5:1.
  13.5:1 is a good place to start at moderate load out of boost. It should be close to 14.7:1 during cruise and then you can use closed loop to lean it out a bit more.
  Under boost, 12.5:1 up to a few PSI, then 12:1 until about 5 PSI, then 11.5:1 from that point on. | 
                     
                    
                        | 
                     
                   
                 |