Aaron's Homepage Forum
Aaron's Homepage Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
 All Forums
 Electronics
 Electronics Repair
 45W LED circuit.

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

   Insert an Image File (GIF, JPG, JPEG, BMP, ZIP, PNG)

   

T O P I C    R E V I E W
Ashirdaniel Posted - Jun 26 2017 : 11:06:40 AM
I have 3 10w white LED's , one 3w red and another 3w blue. I want to light up them to their full potential. What is the best way to do that? I just need to turn them on, don't want to control it's brightness. Can't see any circuit to do that. Can I connect it straight to 12v dc in parallel or do I need to add any resistors.
1   L A T E S T    R E P L I E S    (Newest First)
Aaron Cake Posted - Jun 27 2017 : 09:33:33 AM
You just need to connect to your power source (12V) with series resistors in line with each LED. Connect each resistor/LED pair in parallel.

You'll need to know the voltage of each LED and the current limit.

Then run the numbers though here:
https://www.digikey.ca/en/resources/conversion-calculators/conversion-calculator-led-series-resistor

Remember to calculate power dissipation on the resistor or just use 1W resistors to be safe.

Aaron's Homepage Forum © 1995-2020 AARONCAKE.NET Go To Top Of Page
This page was generated in 0.05 seconds. Snitz Forums 2000