Aaron's Homepage Forum
Aaron's Homepage Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
 All Forums
 Electronics
 Auto
 Automotive Voltage Regulator for MCU

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

   Insert an Image File (GIF, JPG, JPEG, BMP, ZIP, PNG)

   

T O P I C    R E V I E W
Poning Posted - Jan 20 2017 : 04:31:39 AM
To supply 5V to a PIC in a 12-15V automotive environment, I have so far been using variants of 7805s, or the HV varieties of PIC.

While they work, obviously they aren't really of sufficient protection for the environment. In particular reversed polarities, and battery 'jump starts' can cause problems of the destructive variety.

My circuits draw very little current (100mA is a typical maximum) and I solder through hole by hand, so I would avoid SMD.

Can anybody recommend either a good way to protect a simple 7805 (or 78L05), or some alternatives to the 7805 that are more suitable for the environment? I have so far found a suggestion of LM2937(datasheet:http://www.kynix.com/uploadfiles/pdf2286/LM2937ES-12.pdf), but this is relatively very expensive (some 10x more than a 7805)

As a side question, is there a good way to find automotive grade components? I usually use farnell's catalogue, but they don't seem to have 'automotive' in their parametric search so it is a matter of scouring datasheets, which is time consuming.
1   L A T E S T    R E P L I E S    (Newest First)
Aaron Cake Posted - Jan 21 2017 : 10:24:29 AM
As for protecting power inputs, take a look at the power section of the Megasquirt V3 here:
http://www.megamanual.com/ms2/pcb.htm

Basically consists of a MOV, inductive filter and some blocking diodes. My experience has been that the input protection is absolutely adequate. I used a variation of the same design when I recently designed and built an Arduino LED tail light controller:
http://www.aaroncake.net/76cosmo/taillights/

Aaron's Homepage Forum © 1995-2020 AARONCAKE.NET Go To Top Of Page
This page was generated in 0.05 seconds. Snitz Forums 2000